Lily’s Birthday Skates

My Lily girl turned 6 on October 5. S-I-X! I never gave permission for this growing up business. Hmph!

Anyway, last year I made most of her gifts, and we did the whole awesome Adopt-A-Baby Party. We decided not to do big friend birthday parties for the kids this year because of the house being on the market, and with most of my craft supplies in storage, I didn’t do much with handmade gifts.

We did have a small family gathering at the house though, and I did do a bit of upcycling on one gift, which turned out to be her favorite. A month or so ago she was invited to her first school friend birthday party. Have I mentioned that this girl started kindergarten in August? I didn’t? Oh that’s right, it’s because I’m still in denial. But pushing onward, this birthday party was held at the skating rink. Let me just inject a hard earned word of wisdom for you here: don’t wear flip-flops to a 6 year old’s skating party, and no I don’t care to discuss it further. Lesson learned. Anyway, she started out very scared of the whole concept of skating, but by the end of the party I had to dodge speeding skaters to make my way out to the center of the rink to rescue her where she had ventured out and ended up on the floor with no nearby rails on which to pull herself up. She was sold on the wheeled lifestyle.

A few days before her birthday I was at the thrift store and came across these well loved Barbie skates in her size for $3.99.

As you can see, they had some major scuffing on the toes.
So I headed to Walmart where I grabbed a 75 cent clearance fat quarter and a $1 roll of pompom trim from their Halloween ribbon selection. I used a piece of scrap fabric to lay over the toe of one skate to trace around and get a rough idea of the shape I would need to cover the damage, then used that as a template to cut the pieces out of my fat quarter. Then I used Aleene’s Original Tacky Glue to adhere the fabric to the toe, and carefully trimmed away any excess with my Xacto knife. I cut two pieces of trim for each skate, one to go across the top edge of the fabric and one to go around the base of the toe, then hot glued them down using my glue gun on the high setting. Then I snipped off the bows and made new ones using the fat quarter, although I did reuse the center bands since they were in good shape. I just hot glued these back on using the high setting again.

If I do this again, I will seal the fabric with Mod Podge to make them easier to wipe down, but this was completed just a little while before she got home from school, so there wasn’t really time to let it dry.
As you can see, she was pretty excited about them. In fact, she stopped everything to go find a pair of socks and put them on immediately. Her Nana and Papaw bought her knee and elbow pads and a helmet a few days later, and she’s been skating her heart out in the garage ever since. She’s gotten really steady on them, and I’m excited to get to take her back to the skating rink.

Please follow and like us:

Leave a Reply

Your email address will not be published. Required fields are marked *